1INSTALLATION AND OPERATION MANUALM SERIES VACUUM PUMPVACUUM PUMP
2TABLE OF CONTENTSWARNING: When using this product, always exercise basic safety precautions including the following:• Read all instructions before
3Electrical WiringUse adequate wire size and proper over-current protection (fuse or circuit breaker) sizes. Use the following chart as a guideline.
44. Disconnect electrical source to motor, following lock-out/tag-out procedure.5. Remove the six (6) 5/16 in. fasteners around the circumference of
53. Install and adjust rst hex nut for proper bushing clearance of 0.020” [.50mm].4. Hold adjustment nut from turning and install and tighten the l
6G. MOTOR REPLACEMENTTo Remove:1. Turn off electrical power to pump.2. Remove access plate from wiring junction box on motor.3. Unhook wiring from
7TROUBLESHOOTINGWARNING Before attempting to open or service the pump:1. If possible, ush pump with clean water and disinfectant.2. Allow motor
8DIMENSIONSMANUFACTURER’S ONE-YEAR LIMITED WARRANTYDometic Corporation warrants, to the original purchaser only, that this product, if used for person
Commentaires sur ces manuels