Sealand DTM04 Tank Monitor System Manual Manuel d'utilisateur télécharger pdf (Page 5)

INSTALLATION (continued)

Universal Tank Flange Kit (optional)

1. Findandmarkthetopcenterofthetank.

2. Cuta41/16-inchdiameterholeinthetopcenterof

thetank.

3. Sliptheangeintotheholeandmarkthelocation

ofthevemountingholes.

4. Drill the ve mounting holes with a 1/4-inch drill

bit.

5. Removetheange,clean alloils, greaseanddirt

fromthemountingsurfaceandallowtodry.

6. Applyliberalamountsofsiliconerubberadhesive

to the mounting surface and the underside of the

ange.

7. Insertthegasketintotheangeandalignwiththe

vemountingholes.

8. Securetheangewiththescrews,nutsandwashers

provided.

9. Installtheprobecapand,ifapplicable,securethe

5/8-inchventhosetotheventttingwithastainless

steelhoseclamp.

Flange Kit Assembly

Shut-down Relay (optional – applies to DTM04 only)

CAUTION:VERIFYTHATRELAYISCORRECTVOLTAGEFORSYSTEM(12VDCrequiresP/N600341292and

24VDCrequiresP/N600342490).

1. Insertasmallscrewdriverbehindthetoporbottomslotofthepanelcoverandpryitoutward.Removepanel

coverfromcircuitpanel.

2. Removethefourmountingfastenersandpullthecircuitpaneloutofthewallorhullliner,exposingthe

 wiringconnections.

3. Inserttheshut-downrelayintothesocketonthebackofthecircuitpanel.

4. Reinstallthecircuitpaneltothewall.

5. Routetheadditionalwires(use12or14gaugestrandedcopper)towires10and11onpigtailtointerrupt

powerforthetoiletsystem.(Seeshut-downrelaywiringdiagramforapplicationdetails.)

6. Turnonpowerandtestcircuit.

7. Completeinstallationtowall.

Tank

surface

1 2 3 4 5 6 7 8 9

Pas de commentaire

Sealand DTM04 Tank Monitor System Manual Manuel d'utilisateur Page 5