Sealand Duckbill Valve Manuel d'utilisateur télécharger pdf

SeaLand

Duckbill Valve Installation Instructions

1. Flush a substantial amount of soapy water through the pump.

2. Turn off electrical power to pump.

3. Remove both suction (inlet) and discharge (outlet) hoses from the pump.

4. T-SERIES DISCHARGE PUMP ONLY: Remove both valve nipples from suction (inlet) and discharge (outlet) sides

of the pump. (Important: T-Series pumps have left-hand threads on the valve nipples. Turn clockwise to remove.)

Replace old duckbill valves (one required for each side). See T-Series Pump Diagram for correct valve orientation.

S-SERIES VACUUM PUMP ONLY: Remove both valve nipples and valve adapters from suction (inlet) and

discharge (outlet) sides of the pump. Replace old duckbill valves (two required for each side). See S-Series

Pump Diagram for correct valve orientation.

5. Tighten valve nipples and adapters one-half turn beyond hand-tight. NOTE: Overtightening will cause valve

distortion and early failure.

6. Install both suction and discharge hoses and secure with hose clamps.

7. Turn on electrical power and ush water through system to prime pump. Check system for leaks.

S-SERIES VACUUM PUMPT-SERIES DISCHARGE PUMP

600344404

Dometic Corporation

13128 State Rt 226

PO Box 38

Big Prairie, OH 44611

1-800-321-9886

Page 1

SeaLand® Duckbill Valve Installation Instructions1. Flush a substantial amount of soapy water through the pump.2. Turn off electrical power to pum

Pas de commentaire

Sealand Duckbill Valve Manuel d'utilisateur