SeaLand 3100 Spécifications télécharger pdf (Page 49)

APT3100 Smart Pressure Transmitter Operation Manual M3100-EO1G

Duon System Co.,Ltd.

6.4.2.2 Fail Mode and Jumper Switch of EEPROM-write

Fail-mode and jumper switch of EEPROM-write is located front of electronics module(Refer to Figure

2-2, 2-3)

6.4.3 Assembling the Electronics Housing

Re-assembling procedure is same as follows.

1. Make sure that Fail-mode and Jumper Switch are set exactly.

2. Insert electronics module in housing

3. Firstly, connect the connector of sensor board with power connector.

z Mis connection of the two connectors cause wrong output(4~20mA) and effect on power

of Transmitter.

z In case of power connector sandwitched between board and housing, it may cause wrong

output signal and effect on power of transmitter.

4. Fix electronics module with 3 screws.

5. Close the cover of housing..

Figure 6.3 Structure of Electronics Module inner Transmitter

CPU &

Power Module

Analog

Connector

Power(24Vdc)

Connector

1 2 ... 44 45 46 47 48 49 50 51

Pas de commentaire

SeaLand 3100 Spécifications Page 49